Hydraulic Fluid Machinery Lab Equipments

...

open drum orifice

Main supply tank with orifice & mouthpiece fitting arrangement.

Diameter of Orifice-8.5mm,Diameter of mouthpiece-8.5mm.,Nozzle-25mm.&50mm length.

Tracer pointer with scale.

Measuring tank

Product Code : ELSHADDAI HYD - 001

Send A Enquiry

Pipe fiction apparatus

Sudden expansion-1/2”to 1”

Sudden expansion-1/2”to 1”

Differential manometer.

Measuring tank – 400 x 300 x 300mm

Product Code : ELSHADDAI HYD - 002

Send A Enquiry
...
...

Notch apparatus

Types of notch : 600 v notch , rectangular notch, Trapezoidal.

Flow channel : 250 x 250x 1250 mm with notches fitting arrangement

Pipes and Valves : 1” G.I. piping and 1” Brass valves.

Water storage Unit : Sump Tank – 900 x 400 x 400 mm M.S. tank with F.R.P. coating. Or S.S. tank.

Product Code : ELSHADDAI HYD - 003

Send A Enquiry

Centrifugal pump test rig

Measuring tank & stop watch.

Basic piping-1”

Orificemeter & venturimeter

Differential manometer

Product Code : ELSHADDAI HYD - 004

Send A Enquiry
...
...

Bernoulis theorem

Flow channel : 750mm long with transparent solid acryalic

Pipes and Valves : 1” G.I. piping and 1” Brass valves

Water storage Unit : Sump Tank – 900 x 400 x 400 mm M.S. tank with F.R.P. coating. Or S.S. tank.

Product Code : ELSHADDAI HYD - 005

Send A Enquiry

Francis turbine Test Rig

Francis turbine is a reaction turbine which was developed by an English born American engineer Sir J.B Francis. the water enter the turbine though the outer periphery of the runner in The redial direction & leaves the runner in axial direction & hence it is called a mixed flow turbine As the water flow to the the runner a part of pressure energy goes on changing in to kinetic energy. Thus the water though the runner is completely enclosed in a air tight casing & the casing & runner is always full of water.

Product Code : ELSHADDAI HYD - 006

Send A Enquiry
...
...

Kaplan Turbine Test Rig:

Kaplan wheel turbine is an axial flow reaction tubine named in honour named in honour of Sir L Dr. B. Kaplan, a German Engineer.This tubine suitable low head. The power produced by a proportional to QH. Asa head (H) Decrease the discharge (Q) must increase to produce the same power.

Product Code : ELSHADDAI HYD - 007

Send A Enquiry

Metacentric Height Apparatus

Semi Circular Sectioned hollow ship model, provision for loading as Cargo and warship, fine arrangement for accurate angle measurement extra weight in Metric Unit for tilting coupled.

Product Code : ELSHADDAI HYD - 008

Send A Enquiry
...
...

parallel and series pump experiment setup

In complex systems, pumps can be connected in series or in parallel. In serial operation the heads of the pumps are added and in parallel operation the flow rates (capacities) of the pumps are added.

Product Code : ELSHADDAI HYD - 009

Send A Enquiry

PITOT TUBE APPARATUS

A pitot tube made up of small copper tube is held in a pipe line. A screw type arrangement is provided to raise or lower this pitot tube. The open end is connected to a manometer.

Product Code : ELSHADDAI HYD - 010

Send A Enquiry
...
...

Hydraulic Flume Apparatus

A hydraulic flume of c/s 200x300 mm & 6000 mm length with transparent window on either sides of 1000 mm length.

Sliding gates one at upstream and other at the downstream side.

Screw jack for change of the slope of the flume.

A Sump tank of sufficient capacity.

Product Code : ELSHADDAI HYD - 011

Send A Enquiry

FLOW NOZZLE

A flow nozzle meter consists of a short nozzle, usually held in place between two pipe flanges. It is simpler and less expensive than a venturi meter, but not as simple as an orifice meter. The frictional loss in a flow nozzle meter is much less than in an orifice meter, but higher than in a venturi meter.

Product Code : ELSHADDAI HYD - 012

Send A Enquiry
...